Page 1 of 1
Riverside Fire Term
Posted: Sat Jun 21, 2008 10:31 am
by Bill D.
While listening to RFD frequencies, I sometimes hear them use the term "Beverly Hills." What does this refer to? I can't think of an example off the top of my head.
Re: Riverside Fire Term
Posted: Sat Jun 21, 2008 11:05 am
by brandon
Is it possible your hearing Beverly Hills FD? They're also on 460.625/460.575 and can be heard quite well in parts of Riverside County. Make sure you have the PL tone for Riverside Fire entered and it should filter out the Bev Hills stuff.
Re: Riverside Fire Term
Posted: Sat Jun 21, 2008 11:44 am
by Bill D.
My scanner doesn't do pl tones. I would be suprised if it was Beverly Hills. We hear it on my girlfriend's scanner and its reception is not very good. I'll post a transcript of what is said next time I hear it.
Re: Riverside Fire Term
Posted: Sat Jun 21, 2008 9:26 pm
by ke6alv
I agree it's probably Beverly Hills FD, as I too have heard them before when I lived in MoVal.
Re: Riverside Fire Term
Posted: Fri Jul 04, 2008 6:32 am
by convE36
Under the main "Riverside County Fire" page, the PL tone listed for RRU-1 is 131.8
Under the city Canyon Lake, it seems to be listed as 141.3
What is the difference?
Thanks.
Re: Riverside Fire Term
Posted: Fri Jul 04, 2008 9:21 am
by Kingscup
I think it is a typo. 141.3 is correct.
Re: Riverside Fire Term
Posted: Tue Jul 22, 2008 1:05 am
by 211
Does anyone know where the Beverly Hills Fire antenna site is? Is it up on Mt. Wilson or something, or is down in the city somewhere?